When using the Huaquan generator in spring, targeted maintenance and operation adjustments should be made based on the characteristics of the spring climate, such as high humidity, temperature fluctuations, and increased thunderstorms, to ensure its safe and stable operation. The following are key precautions and specific measures. I hope the following introduction can provide users with reference.

1、 Huaquan Generator Filter and Fuel System Maintenance

Replace or clean the "three filters"

Huaquan generator air filter: In spring, there is an increase in sandstorms and pollen, so it is necessary to increase the cleaning frequency (it is recommended to check every 50 hours). Damaged filter elements should be replaced in a timely manner to prevent dust from entering the cylinder.

Fuel filter: Regularly drain the accumulated water in the fuel tank (once every 15 days), replace the filter element, prevent microbial growth and blockage of the oil circuit, and add diesel bactericides if necessary.

Oil filter: Clean or replace to ensure smooth oil flow and avoid impurities causing lubrication failure.

Fuel management

Use impurity free diesel and avoid fuels containing ethanol or methanol to prevent engine corrosion.

The oil storage tank should be sealed and moisture-proof, and the oil pipeline should be checked regularly for leaks.

 

2、 Huaquan Generator Lubrication and Cooling System Adjustment

Change seasonal engine oil

If the instruction manual requires winter and summer engine oil, it should be replaced with summer viscosity engine oil in spring and the oil circuit should be cleaned.

Check the oil level to avoid excessive or insufficient lubrication and ensure effective lubrication.

Cooling system maintenance

Clean the radiator, remove willow catkins and dust, and prevent overheating.

Check the freezing point and pH value of the antifreeze, and replace the failed liquid in a timely manner.

3、 Moisture and Lightning Protection of Huaquan Generator Electrical System

Moisture-proof treatment

Check the oxidation condition of the battery terminals, apply Vaseline to prevent corrosion, and maintain stable battery voltage.

Blow out moisture with compressed air inside the control cabinet and check if the circuit joints are loose or oxidized.

lightning protection

Ensure grounding resistance, check if lightning rods and surge protectors are functioning properly, and turn off non essential equipment before thunderstorms.

 

4、 Huaquan Generator Operation and Load Management

Start up and preheating

Power on and preheat before cold start to avoid damaging the battery from multiple consecutive starts.

Run without load for 3-5 minutes before gradually loading to prevent sudden load from causing engine detonation.

Operation Monitoring

Monitor water temperature, oil pressure, and exhaust color, and immediately shut down for inspection in case of abnormalities.

Avoid prolonged low load operation to prevent engine damage caused by "wet accumulation".

5、 Huaquan Generator Environment and Security Protection

Flood control and ventilation

Check the drainage system of the machine room, and prepare sandbags or pumps to prevent water from flowing back in rainstorm.

Maintain good ventilation in the computer room, avoid carbon monoxide accumulation, and use dehumidifiers if necessary.

Cleaning and anti-corrosion

Clean the generator casing to prevent corrosion caused by water accumulation and moisture.

Check whether the pipelines and valves are corroded, and repair or replace them in a timely manner.

 

During spring maintenance of the huaquan generator, attention should be paid to moisture prevention, blockage prevention, and overload prevention. It is necessary to focus on controlling the filters, fuel, lubrication, and electrical systems. Extend equipment usage time through regular inspections, environmental adaptability adjustments, and standardized operations.
More information on huaquan generator:http://www.huaquan98.com/